Segen Quick Change System

Precise mechanical systems provide fast, accurate tool changeover.






Quick Change | Thermoforming Accessories | Tooling Technology

Peening Hammer

Renew worn trim tooling, eliminate angel hair and fuzz.

Peening HammerA must for any one running punch and die or matched-metal trim tooling. This remarkable peening hammer can be used to renew worn tooling without the time and cost associated with pulling the trim tool out of the press. After the first time you "peen back to life" excessive clearance between worn punch and die, this proven tool will have paid for itself!

Saves thousands by drastically reducing downtime associated with tool maintenance.

Recondition a worn punch or die so your tooling can be back in operation within minutes. Our peening hammer is shaped and designed to deliver 6,000 blows per minute with the proper force to cause steel to yield and flow in the precise form and direction.


Penning Hammer

Profitable results in only a few minutes!

Peen worn punches and dies right inside your trim presses!

Catalog #




general informationoperation guide

Depending on the hardness of the material being peened and the amount of hours used, the moving parts of your Peening Hammer will eventually begin to wear.  After excessive peening, the Piston will begin to "mushroom" on the end and should be replaced in order to retain optimum performance.  As a general rule, most of our customers prefer to replace both the Piston and the Nozzle at the same time. Please click on the button below to open a list of Peening Hammer spare parts, along with diagrams and current pricing.

spare parts pricing

contact us